HP Surestore 64 - Director Switch Installation Manual page 64

Installing and Configuring the Director 2/64
3. Attach the bracket with 10-32, flat-head Phillips screws (4) using the two
4. Repeat
Figure 22: Installing the rack mounting brackets on the switch
5. Locate the two rear mounting brackets in the shipping carton.
6. Position a rear mounting bracket (3) so that the bracket's center holes (1)
Note:
switch.
7. Secure the rear mounting bracket to the switch using two 10-32, flat-head
8. Repeat
64
center threaded holes on the front side of the switch.
step 2 and step 3
line up with the 1st and 3rd threaded holes on the back portion of the switch
side.
The slotted end (
Phillips screws.
step 6 and step 7
for the second front mounting bracket.
) of the bracket should face toward the back of the
2
for the second rear mounting bracket.
Director 2/64 Installation Guide