Set Date And Time Manually - HP Surestore 64 - Director Switch Installation Manual

Installing and Configuring the Director 2/64
3. Set director date and time manually, or set for periodic updates. For specific
Figure 39: Configure Date and Time dialog box

Set Date and Time Manually

Use these steps to set the director date and time manually:
1. At the Configure Date and Time dialog box, click the Periodic Date/Time
2. Click the Date fields that require change, and type numbers in the following
3. Click the Time fields that require change, and type numbers in the following
4. Click Activate to set the director date and time, and close the Configure Date
84
instructions, see the following sections:
Set Director Date and
Synchronize Date and
Synchronization check box to deselect the option (no check mark in the box).
The grayed-out Date and Time fields activate.
ranges:
Month (MM): 1 through 12
Day (DD): 1 through 31
Year (YYYY): greater than 1980
ranges:
Hour (HH): 0 through 23
Minute (MM): 0 through 59
Second (SS): 0 through 59
and Time dialog box.
Time, page 83
Time, page 85
Director 2/64 Installation Guide