Enable Embedded Web Server
Use the following steps to enable EWS:
1. At the Hardware View page, choose Configure > Enable Web Server.
2. Choose Enable Web Server again to remove the check mark and disable the
For complete procedures on using EWS, refer to the HP StorageWorks Embedded
Web Server User Guide.
Enable Telnet
Use the following steps to enable Telnet:
1. At the Hardware View, choose Configure > Enable Telnet. Choosing
2. Choose Enable Telnet again to remove the check mark and disable telnet
Connect Cables to the Fibre Channel Ports
Use these steps to connect Fibre Channel port cables:
1. Route the fiber-optic cables from customer-specified devices to ports at the
Director 2/64 Installation Guide
Choosing Enable Web Server automatically places a check mark in the
check box.
EWS interface. When disabled, remote users cannot access the interface.
Enable Telnet automatically places a check mark in the check box.
access. When disabled, remote users cannot access the director through telnet.
front of the Director 2/64, as shown in
Installing and Configuring the Director 2/64
Figure
54.
111