The Balmoral Front - FPI P36D-NG Owners & Installation Manual

1) Bend tabs located at the back of the Balmoral Front upwards 90
degrees.
Backside of Front shown.
2) Secure the bottom frame of the Front by loosening the inner screw
on the hinge brackets on both the left and right side of the firebox.
Slide frame in place and secure.
Hinge bracket on
bottom of firebox
Balmoral Front
frame
3) Slide tabs into louver brackets located on the inside top of the firebox.
FPI P36D Zero Clearance Direct Vent Gas Fireplace
THE BALMORAL FRONT INSTALLATION
Bend tab
upwards 90
degrees.
Left Side Shown
Tabs
Bracket inside
top of firebox.
PALACE SERIES OPTIONS
4) Remove existing control switch box from under firebox by discon-
necting wires connected to the valve at TH-TH/TP terminals and
discard.
Control Box
5) Connect the ON/OFF switch wires coming from the left side of the
Front to the valve, with black hooked up to the TH/TP terminal and red
hooked up to the TH terminal.
NOTE: If fan option is not used please see step (5) of optional fan
installation for placement of fan control box.
Fan Control Box
6) For optional fan installation, see page 60.
7) For 2-panel & 3-panel door installation, see page 61.
Wires connected to Valve.
Valve
ON/OFF Switch
Wires
59