INSTALLATION
IMPORTANT: Please use the gloves provided when handling the Kensington
®
1) Place the Kensington
Front up against the unit , but do not secure.
Make the following wire connections:
Connect the fan switch wires by taking the black and red wires with
the male ends (in the grey harness) and connect them with the wire
connectors from the fan speed control.
Connect the ON/OFF switch wires by taking the black and red wires
with the female ends and connect them to the ON/OFF switch.
Tuck the wires into the faceplate to keep them away from the insert
using the clip provided. Attach the clip to the rear of the faceplate to
ensure that the wires do not touch the side of the unit.
The power cord should be run behind the faceplate panel.
24
THE KENSINGTON
FRONT INSTALLATION
2) Mount the Kensington
using 4 screws, 2 per side.
Kensington
Front
3) Slide the Tabs on the Blanking Plate into the slots located on Front
and secure using 2 screws.
Kensington
Front
Blanking
Plate
Screw
®
®
Front to avoid fi ngerprints.
®
Front onto the fi rebox by securing in place
®
Screws
Blanking Plate Tabs
®
U32-5 FPI Direct Vent Gas Insert
Left Side
Shown
Screw