Brick Panels (Optional); Log Set Installation - FPI P36D-NG Owners & Installation Manual

P36d zero clearance direct vent gas fireplace
Table of Contents

Advertisement

INSTALLATION
OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel first by carefully
slipping it between the back wall of the
firebox and the rear log bracket.
3) Put the side panels in next. Slide them in
from the front and push them flat up against
the wall. Be very careful not to scratch
them on the firebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
Note: If the bottom brick panel must be re-
moved: Remove the Rear Log Stand, then
remove the Burner Tray.
.
36
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can
interfere with the pilot
operation.
The gas log kit (Part # 780-930) contains the
following pieces:
a) 02-75 Rear Log
b) 02-55 Middle Left Log
c ) 02-50 Front Left Log
d) 02-53 Center Left Log
e) 02-51 Front Bottom Log
f ) 02-54 Center Right Log
g) 02-52 Middle Right Log
h)
Embers
02-55
02-75
02-50
02-53
02-51
The "02" refer numbers (i.e. 02-75) are
molded into the rear of each log.
NOTE: If you will be installing the optional
Brick Panels, install the Brick Pan-
els prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite all over the top of the
base brick panel.
3) Place the Log 02-75 on the rear log support
pins with the flat side to the back.
02-75
4) Place Log 02-51 on the front right side of
the burner. Push the back of the log against
the 2 brackets with the notch on the bottom
right side of the log fitting into the right side
of the grate.
02-75
Bracket
02-51
02-52
5) Position Log 02-53 across the cutouts in
Logs 02-75 and 02-51 with the notch on the
left side of the log fitting into the 2nd grate
02-54
tab.
2nd Grate Tab
6) Position Log 02-54 across the cutouts in
Logs 02-51 and 02-53. The notch in the
bottom right end fitting against the 5th grate
tab.
FPI P36D Zero Clearance Direct Vent Gas Fireplace
02-51
Bracket
Notch
Notch
02-53
02-75
02-51
Cutouts
02-51
02-53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

P36d-lp

Table of Contents