Ricoh Aficio GX e3300N User Manual page 73

Specifying the Interface and Network Settings using the Printer's Control Panel (Host Interface Menu)
Specifying the Interface and Network Settings
using the Printer's Control Panel (Host Interface
Menu)
In the Host Interface menu, you can make network settings and settings for the computer to printer USB
connection (if used). Settings made using the Host Interface menu remain effective even if you turn the
printer off.
To configure the printer's network settings, use "Network Setup" on the printer's control panel.
I/O Timeout
Specify how long the printer waits for the currently-connected interface to respond. When the specified
time elapses, the printer can receive data from another interface.
If you make the I/O Timeout period too short, timeout might occur while data transfer is in progress.
If this happens, the print job will be interrupted by a new job from another interface.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Default: 15 seconds
Network Setup
You can make network-related settings.
Note that the GX e2600 cannot be connected to networks.
DHCP
You can specify the DHCP.
• On
• Off
Default: On
IP Address
You can specify the IP address.
When DHCP is set to on, the IP address cannot be changed. To change it, set DHCP to off.
Contact your network administrator for information about the network configuration.
GX e3300N: Default: 11.22.33.44
GX e3350N: Default: 0.0.0.0
2
71