Ricoh Aficio GX e3300N User Manual page 388

2. Preparing for Printing
Notes on the Installation (USB Connection)
If the message "Digital Signature Not Found" or the [Software Installation] , [Hardware
Installation] or [Windows can't verify the publisher of this driver software] dialog box
appears:
1. Click [Yes], [Continue Anyway] or [Install this driver software anyway] to continue the
installation.
2
If the [Found New Hardware Wizard] dialog box appears:
1. Click [Install from a list or specific location (Advanced)], and then click [Next >].
2. Click [Include this location in the search], and then click [Browse].
3. Browse to "DRIVERS" on the CD-ROM, and then click [OK]. Select the folder appropriate
for your operating system.
Be sure to clear the [Search remove media (floppy, CD-ROM...)] check box.
For details about the files stored on the CD-ROM labeled, see p.287 "Software on the
CD-ROM".
1. Start Windows, and insert the provided CD-ROM into the CD-ROM drive.
Quit all applications currently running.
When you start Windows, the "Add New Hardware Wizard" may appear. If this happens, click
[Cancel]. Check again that the power is off.
2. Select a language for the interface, and then click [OK].
3. Click [Quick Install for USB].
4. Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement.], and then click [Next >].
5. Check that the power of the printer is off, and then click [Next >].
6. Check again that the power of the printer is off, and then click [Next >].
Check that the dialog box below appears.
If the [Software Installation] or [Windows can't verify the publisher of this driver software] dialog box
appears, see "Notes on the Installation".
7. Make sure that the computer and printer are properly connected, and then press the [Power]
key.
Installation starts.
If the connection to the computer was not confirmed, make the port settings again after installation is
complete.
If the message "Digital Signature Not Found" or the [Found New Hardware Wizard] or [Hardware
Installation] dialog box appears, see "Notes on the Installation".
8. Select whether or not to open the printer status monitor automatically, and then click [Next
>].
58