When You Cannot Print - Ricoh Aficio MP C2500 EFI Troubleshooting Manual

When You Cannot Print

Use the following procedures if printing does not start even after performing
[Print].
Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Cause
The power is off.
The machine is set to "Offline".
The cause is displayed on the dis-
play of the control panel.
The interface cable is not connect-
ed correctly.
The correct interface cable is not
being used.
The interface cable was connect-
ed after the machine was
switched on.
If the machine is operating in an
extended wireless LAN, failure to
print might result from a weak
wireless signal.
If the machine is operating in an
extended wireless LAN, SSID set-
tings are incorrect.
When You Cannot Print
Solution
Check the cable is securely
plugged into the power outlet
and the machine. Turn on the
main power switch.
Press {Online} key.
Check the error message or warn-
ing status on the display panel
and take the required action.
Connect the interface cable se-
curely. If it has a fastener, fasten
that securely as well. See "Con-
necting to the Interfaces", General
Settings Guide.
The type of interface cable you
should use depends on the com-
puter. Be sure to use the correct
one. If the cable is damaged or
worn, replace it. See "Connecting
to the Interfaces", General Set-
tings Guide.
Connect the interface cable before
turning on the machine.
To check signal status, press {Us-
er Tools / Counter / Enquiry} key,
and then press [System Settings]
on the display panel. On the [In-
terface Settings] tab, select [IEEE
802.11b], and then press [Wireless
LAN Signal]. If signal quality is
poor, move the machine to a loca-
tion where radio waves can pass
or remove objects that might
cause interference.
(You can check signal status only
when using wireless LAN in the
infrastructure mode.)
Check using the machine's dis-
play panel that the SSID is cor-
rectly set. See "Network Settings",
General Settings Guide.
4
53