IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual page 227

Beep/Symptom
3-2-3(Math coprocessor failed)
3-2-4(Failure comparing CMOS
memory size against actual)
3-3-1(Memory size mismatch
occurred, see "Memory Settings" on
page 47)
3-3-2(Critical SMBUS error
occurred)
3-3-3 (No operational
memory in system)
Two Short Beeps (Information only,
the configuration has changed)
Three Short Beeps
One Continuous Beep
Repeating Short Beeps
One Long and One Short Beep
1. Optional processor (if installed)
2. Processor
3. Processor/PCI board
1.
DIMM
2. Processor/PCI board
3. Battery
4. I/O Legacy board
1. DIMM
2. Processor/PCI board
3. Battery
1. Disconnect the server power cord from outlet, wait 30 seconds and retry.
2. I/O Legacy Board
3. Processor/PCI Board
4. DIMMs
5. Memory Card
6. DASD Backplane
7. Power Supply
8. Power Supply Backplane
9. 12C Cable
1. Install or reseat the memory modules, then power-on the system (see
"Using the Configuration/Setup Utility program" on page 43).
2. If problem persists, restart the system 3 times.
Note: Restarting the system three times will load default settings.
3. DIMMs
4. Memory Board
5. Processor/PCI Board
6. I/O Legacy Board
1.
Run Diagnostics
2. Run Configuration/Setup
1.
DIMM
2. Processor/PCI Board
3. I/O Legacy Board
1. Processor
2. Optional Processor (if installed)
3. Processor/PCI Board
4. I/O Legacy Board
1. Keyboard
2. I/O Legacy Board
1.
Video adapter (if present)
2. I/O Legacy Board
FRU/Action
Symptom-to-FRU index
217