Memory Card Removal - IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual

Memory card removal

130
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
1. Power-off the server off, if it is on.
2. Disconnect the power cord for each power source from the electrical outlet.
Attention: The presence of ac standby power might result in damage to the
hardware unless you disconnect the power cord for each power source from the
electrical outlet.
3. Remove the top cover (see "Removing the top cover" on page 62).
4. Disconnect the shuttle (see "Disconnecting the shuttle" on page 128.)
5. Remove the shuttle (see "Removing the shuttle" on page 135).
6. Remove the four shuttle screws (two on each side).
7. Push in on the shuttle touchpoints.
8. Separate the shuttle from the I/O Legacy board.
9. To replace the I/O Legacy board, reverse this procedure.
Before you begin:
• Read "Safety information" on page 249.
• Review "Before you begin" on page 60.