Disconnecting the shuttle
Front LED card assembly
128
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
8.
Replace the card and reattach the front LED card cable and the diagnostic switch
card cable.
Review the information in "Before you begin" on page 60.
1.
Power-off the server, if it is on.
2.
Disconnect the power cord for each power source from the electrical outlet.
Attention: The presence of ac standby power might result in damage to the
hardware unless you disconnect the power cord for each power source from the
electrical outlet.
3.
Remove the top cover (see "Removing the top cover" on page 62).
4.
Flip the top end of each diagonal side latch inward.
5.
Move each latch toward the rear of the shuttle until the latch is vertical.
6.
Fold the hinged top end of each latch outwards at the notch of the chassis.
7.
Slide the shuttle toward the rear of the server.
8.
To remove the shuttle, see "Removing the shuttle" on page 135.
Review the information in "Before you begin" on page 60.