Starting The Netfinity Manager Installation Program - IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual

Starting the Netfinity Manager installation program

98
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
— NetBIOS
Note: The Netfinity Manager NetBIOS requirements are three names, two
sessions, and nine network control blocks (NCBs).
— IPX
— SNA (Microsoft SNA Server version 2.11 with Service Pack 1 and
WCPIC32.DLL dated 01/22/97 or later. This DLL is available from
Microsoft)
Note: Systems using Netfinity Manager with Microsoft SNA Server cannot
communicate with systems running the Microsoft SNA Server client.
Netfinity Manager supports only server-to-server communications
between systems running Microsoft SNA Server software. However,
Netfinity Manager systems running Microsoft SNA Server can
communicate with Netfinity Manager systems using any of the other
supported SNA stacks.
• A 9600 baud or greater modem (optional).
The hard disk requirement for Client Services for Netfinity Manager is 6.5 MB–9 MB
of hard disk space. All other system requirements are the same as for Netfinity
Manager for Windows NT.
Notes:
1.Serial Connection Control will not function on systems that do not have a properly
installed and configured modem.
2.To most effectively manage Windows NT systems, any user that will be using
Netfinity Manager on a Windows NT system (locally or remotely) must have
administrator-level access to the system.
For instructions on installing Client Services for Netfinity Manager, see the
documentation listed in "Getting more information about Netfinity Manager" on
page 122.
To start the Netfinity Manager installation program on a system that is running
Windows NT 4.0:
1. Start the computer with your operating system.
2. Place the ServerGuide Netfinity Applications CD into the CD-ROM drive.
3. Follow the instructions for your operating system below:
• OS/2 Warp Server
a. From a command prompt, type
x
where x is the CD-ROM drive letter, and then press Enter.
b. Type
and then press Enter. The ServerGuide Netfinity Applications windows
opens.