IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual page 158

11. Connect the other end of the SCSI cable to the Active PCI backplane or to a SCSI
12. If you have physical drives to install, install them now. See your server
13. Install the server cover.
14. If you disconnected the cables and power cords in step 2 on page 146, reconnect
148
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
Notes:
a. See "Features and connector locations of ServeRAID-4H controller" on page
139 for the channel connector locations of the 4H controller, "Features and
connector locations of ServeRAID-4L controller" on page 141 for the channel
connector locations of the 4L controller, and "Features and connector
locations of ServeRAID-4M controller" on page 143 for the channel connector
locations of the 4M controller.
b. The following illustration depicts the ServeRAID-4H controller. The
ServeRAID-4L controller will have a slightly different appearance.
Figure 5. Connecting a ServeRAID-4H controller internal
channel connector
device in the server. (See your server documentation or the system label inside the
server cover for the location of the SCSI connector on the backplane.)
documentation for drive installation instructions.
Note: The ServeRAID controllers use SCSI ID 7 and/or 6.
the cables and cords. See your server documentation if you need detailed
instructions.