Table of Contents
Advertisement
debug cable qos
debug cable qos
To activate quality-of-service (QoS) debugging, use the debug cable qos command in privileged EXEC
mode. To disable debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Release
11.3NA
Usage Guidelines
This command activates debugging of QoS. When this command is activated, any messages related to
QoS parameters are displayed on the Cisco CMTS console.
Examples
The following is typical output from the debug cable qos command:
CMTS_QOS_LOG_NO_MORE_QOS_INDEX
Modems cannot add more entries to the class of service table.
CMTS_QOS_LOG_NOMORE_QOSPRF_MEM
Memory allocation error when creating class of service table entry.
CMTS_QOS_LOG_NO_CREATION_ALLOWED
Class of service entry cannot be created by modem.
interface instead of the modem's TFTP configuration file.
CMTS_QOS_LOG_CANNOT_REGISTER_COS_SID
A service identifier (SID) could not be assigned to the registering modem.
CMTS_QOS_LOG_CANNOT_DEREGISTER_COS_SID
The modem's service identifier (SID) was already removed.
CMTS_QOS_LOG_MSLOT_TIMEBASE_WRAPPED
The 160 KHz timebase clock drives a 26-bit counter which wraps around
approximately every 7 minutes.
wraps around.
Cisco Broadband Cable Command Reference Guide
5-60
debug cable qos
no debug cable qos
Modification
This command was introduced.
This message is generated every time it
Chapter 5
Cisco CMTS Debugging Commands
Use CLI or SNMP
OL-1581-08
Advertisement
Table of Contents
