Table of Contents
Advertisement
history
history
To display the last 16 commands given at the ROM monitor prompt, use the history command in ROM
monitor mode.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values.
Command Modes
ROM monitor
Command History
Release
11.3 NA
12.1(5)EC
12.2(4)BC1
Usage Guidelines
The ROM monitor keeps a record of the last commands given at the ROM monitor prompt (up to 16),
similar to the way this is done with the Korn shell. Use the history command to display these commands,
and the
When you use an alias, the history list includes the alias and not the actual commands that were
Tip
executed.
The
Note
Examples
The following example shows how to reset the ROM monitor and return it to a known state:
rommon 9 > history
1
2
3
4
5
6
7
8
Cisco Broadband Cable Command Reference Guide
A-30
history
Modification
This command was introduced on Cisco uBR7200 series routers.
Support was added for Cisco uBR7100 series routers.
Support was added for the Cisco uBR10012 router. Changes were also made
to the boot procedure after breaking into ROMMON to ensure that all
hardware and software registers are in a known state before loading the new
image.
repeat
command to repeat them one or more times.
repeat
command is not added to the history list.
boot sysfiles/ubr10k-k8p6-mz.12211BC3
dev
dir disk0:
confreg
confreg 0x00
cont
break -c
break
Appendix A
Using the ROM Monitor
OL-1581-07
Advertisement
Table of Contents
