Cisco SR2016T-NA Reference Manual page 1032

crypto ipsec client ezvpn (global configuration)
crypto ipsec client ezvpn (global configuration)
To create a Cisco Easy VPN Remote configuration and enter the Cisco Easy VPN Remote configuration
mode, use the crypto ipsec client ezvpn command in global configuration mode. To delete the
Cisco Easy VPN Remote configuration, use the no form of this command.
A separate crypto ipsec client ezvpn command exists in interface configuration mode that assigns a
Note
Cisco Easy VPN Remote configuration to the interface.
Syntax Description name
Defaults Newly created Cisco Easy VPN Remote configurations default to client mode.
Command Modes
Global configuration
Command History Release
12.2(4)YA
12.2(8)YJ, 12.2(15)T
Usage Guidelines The crypto ipsec client ezvpn command creates a Cisco Easy VPN Remote configuration and then
enters the Cisco Easy VPN Remote configuration mode, at which point you can enter the following
subcommands:
•
•
Cisco Broadband Cable Command Reference Guide
6-30
crypto ipsec client ezvpn name
no crypto ipsec client ezvpn name
Identifies the Cisco Easy VPN Remote configuration with a unique,
arbitrary name.
Modification
This command was introduced for Cisco 806, Cisco 826, Cisco 827, and
Cisco 828 routers; Cisco 1700 series routers; and Cisco uBR905 and
Cisco uBR925 cable access routers.
This command was enhanced to enable you to manually establish and
terminate an IPSec VPN tunnel on demand for Cisco 806, Cisco 826,
Cisco 827, and Cisco 828 routers; Cisco 1700 series routers; and
Cisco uBR905 and Cisco uBR925 cable access routers.
connect [ | ]—To manually establish and terminate an IPSec VPN tunnel on demand.
auto manual
The option is the default setting, because it was the initial Phase I functionality. The IPSec
–
auto
Virtual Private Network (VPN) tunnel is automatically connected when the Cisco Easy VPN
Remote feature is configured on an interface.
The option specifies the manual setting to direct the Cisco Easy VPN Remote to wait
–
manual
for a command or API call before attempting to establish the Cisco Easy VPN Remote
connection. When the tunnel times out or fails, subsequent connections have to wait for the
command to reset to manual or an application program interface (API) call.
default—Sets the following command to its default values.
Chapter 6 Cable CPE Commands
OL-1581-07