Table of Contents
Advertisement
Appendix A
Using the ROM Monitor
cpu_card_type
To display the type of processor card that is installed in the router, use the cpu_card_type command in
ROM monitor mode.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values.
Command Modes
ROM monitor
Command History
Release
11.3 NA
12.1(5)EC
12.2(4)BC1
Examples
The following example shows that the router is using an NPE-225 processor card:
rommon 92 > cpu_card_type
CPU card type is NPE-225
rommon 93 >
Related Commands
Command
boot
sysreset
OL-1581-07
cpu_card_type
Modification
This command was introduced on Cisco uBR7200 series routers.
Support was added for Cisco uBR7100 series routers.
Support was added for the Cisco uBR10012 router. Changes were also made
to the boot procedure after breaking into ROMMON to ensure that all
hardware and software registers are in a known state before loading the new
image.
Description
Boots the router manually.
Displays the return information from the system image that was last booted.
Cisco Broadband Cable Command Reference Guide
cpu_card_type
A-21
Advertisement
Table of Contents
