Table of Contents
Advertisement
debug redundancy
debug redundancy
To enable debugging of the Route Processor Redundancy (RPR) feature and its background procedures,
use the debug redundancy command in Privileged EXEC mode.
Syntax Description
alarms
all
configsync
fsm
keepalive
peer-monitor
rf-fsm
services
timesync
Command Modes
Privileged EXEC
Command History
Release
12.2(4)XF1
12.2(11)BC3
Examples
The following example shows all redundancy debugging messages being enabled:
Router# debug redundancy all
Redundancy All debugging is on
Router#
The following example shows typical messages that the debug redundancy alarms command displays:
Router# debug redundancy alarms
Redundancy Alarms debugging is on
Router#
Cisco Broadband Cable Command Reference Guide
5-140
debug redundancy {alarms | all | configsync | fsm | keepalive | peer-monitor | services |
timesync}
Enables debugging messages for alarms sent because of redundancy
procedures.
Enables all redundancy debugging messages.
Enables debugging messages for the synchronization of the configuration
files.
Enables debugging for changes in the redundancy finite state machine
(FSM).
Enables debugging messages for the keepalive messages sent between
Performance Routing Engine (PRE1) modules.
Enables debugging messages for the standby PRE1 module's monitoring of
the active PRE1 module.
Enables debugging for changes in the redundancy finite state machine
(FSM).
Enables debugging for the services requested during redundancy
processing.
Enables debugging messages for time synchronization procedures.
Modification
This command was introduced for the Cisco uBR10012 router.
The fsm option was renamed to rf-fsm.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
