Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
Table 6-13 show controller cable-modem mac state Field Descriptions (continued)
Field
Concatenation
Maximum CPEs
Vendor ID
Auth. Wait Timeout
Reauth. Wait Timeout
Auth. Grace Time
Op. Wait Timeout
Retry Wait Timeout
TEK Grace Time
Auth. Reject Wait Time
Assigned SID
Max Downstream Rate
Max Upstream Rate
Upstream Priority
Min Upstream Rate
Max Upstream Burst
Privacy Enable
Ranging Backoff Start
Ranging Backoff End
OL-1581-07
Description
Indicates whether DOCSIS 1.1 concatenation is enabled or disabled.
Maximum number of CPEs supported for this cable modem.
Unique identifier specifying the CM manufacturer.
Number of seconds the router waits for a reply after sending the
Authorization Request message to the CMTS.
Number of seconds the router waits for a reply after it has sent an
Authorization Request message to the CMTS in response to a
reauthorization request or an Authorization Invalid message from the
CMTS.
Number of seconds before the current authorization is set to expire that the
grace timer begins, signaling the router to begin the reauthorization
process.
Number of seconds the TEK state machine waits for a reply from the
CMTS after sending its initial Key Request for its SID's keying material.
Number of seconds the TEK state machine waits for a replacement key for
this SID after the TEK grace timer has expired and the request for a
replacement key has been made.
Number of seconds before the current TEK is set to expire that the TEK
grace timer begins, signaling the TEK state machine to request a
replacement key.
Number of seconds the router waits before sending another Authorization
Request message to the CMTS after it has received an Authorization
Reject message.
Service ID assigned by the CMTS for the corresponding service class.
Maximum downstream rate in bits per second that the CMTS is permitted
to forward to CPE unicast MAC addresses learned or configured as
mapping to this router. This rate does not include MAC packets addressed
to broadcast or multicast MAC addresses.
Maximum upstream rate in bits per second that the router is permitted to
forward to the RF network. This rate includes packet PDU data packets
addressed to broadcast or multicast addresses.
Relative priority assigned to this service class for data transmission in the
upstream channel. Higher numbers indicate higher priority.
Date rate in bits per second that will be guaranteed to this service class on
the upstream channel.
Maximum transmit burst in bytes allowed for this service class on the
upstream channel.
Indicates whether or not Baseline Privacy is enabled for this service class.
Initial back-off window for initial ranging contention, expressed as a
power of 2. Valid values are from 0 to 15.
Final back-off window for initial ranging contention, expressed as a power
of 2. Valid values are from 0 to 15.
Cisco Broadband Cable Command Reference Guide
show controllers cable-modem mac
6-111
Advertisement
Table of Contents
