Cisco SR2016T-NA Reference Manual page 1129

Reference guide
Hide thumbs Also See for SR2016T-NA:
Table of Contents

Advertisement

Chapter 6
Cable CPE Commands
Table 6-16 show controllers cable-modem qos Field Descriptions (DOCSIS 1.1) (continued)
Field
valid
Match
SIDT
Packet Classifier Details
Classifier ID
SFID
IP source
IP dest
UDP/TCP source range The low-end and high-end matching source TCP/UDP port values.
UDP/TCP dest range
IP Protocol
PHS
Downstream Payload
Header Suppression
OL-1581-07
Description
A 13-bit bitmask showing which Type/Length/Value (TLV) fields were set
on the classifier. The following shows the meaning of each bit, with the
least significant bit on the far right. The bit is set to 1 if the corresponding
TLV was set for the classifier:
0x0001—IP Type of Service Range and Mask
0x0002—IP Protocol
0x0004—IP Source Address
0x0008—IP Source Mask
0x0010—IP Destination Address
0x0020—IP Destination Mask
0x0040—TCP/UDP Source Port Start and TCP/UDP Source Port End
0x0080—TCP/UDP Destination Port Start and TCP/UDP Destination
Port End
0x0100—Destination MAC Address
0x0200—Source MAC Address
0x0400—Ethertype/DSAP/MacType
0x0800—IEEE 802.1P User_Priority
0x1000—IEEE 802.1Q VLAN_ID
For example, a value of D6 translates to the bit-mask "1101 0110", which
indicates that the following fields were set for the classifier: IP Protocol,
IP Source Address, IP Destination Address, and the TCP/UDP Source and
Destination Port values.
Number of packets matching the classifier.
Address for the classifier in the internal SID table (SIDT).
Describes each packet classifier in detail.
ID used to uniquely identify the classifier in each service flow.
ID that uniquely identifies the service flow.
The matching IP source address.
The matching IP destination address.
The low-end and high-end matching destination TCP/UDP port values.
The matching IP protocol type, as given in
matches any IP protocol, and a value of 257 matches TCP and UDP traffic.
Indicates whether Payload Header Suppression (PHS) is active or inactive.
Indicates that PHS is being used on the downstream.
Cisco Broadband Cable Command Reference Guide
show controllers cable-modem qos
RFC
1700. A value of 256
6-127

Advertisement

Table of Contents
loading

This manual is also suitable for:

Broadband cable

Table of Contents