Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
interface usb
To enter the interface configuration mode for the Universal Serial Bus (USB) interface, use the interface
usb command in global configuration mode.
Cisco uBR925 cable access router, Cisco CVA122 Cable Voice Adapter
Syntax Description
number
Defaults
Disabled
Command Modes
Global configuration
Command History
Release
12.1(5) XU1
12.2(2)XA
Usage Guidelines
When this command is entered, the router switches from global configuration mode to interface
configuration mode for the USB interface.
Examples
The following example shows how to enter interface configuration mode for the USB interface and then
to display the available commands:
Router(config)# interface usb 0
Router(config-if)#?
Interface configuration commands:
access-expression
arp
bandwidth
bridge-group
carrier-delay
cdp
crypto
custom-queue-list
default
delay
description
exit
fair-queue
h323-gateway
help
hold-queue
ip
keepalive
OL-1581-07
interface usb number
Identifies the USB interface (always 0).
Modification
This command was introduced for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
Build a bridge boolean access expression
Set arp type (arpa, probe, snap) or timeout
Set bandwidth informational parameter
Transparent bridging interface parameters
Specify delay for interface transitions
CDP interface subcommands
Encryption/Decryption commands
Assign a custom queue list to an interface
Set a command to its defaults
Specify interface throughput delay
Interface specific description
Exit from interface configuration mode
Enable Fair Queuing on an Interface
Configure H323 Gateway
Description of the interactive help system
Set hold queue depth
Interface Internet Protocol config commands
Enable keepalive
Cisco Broadband Cable Command Reference Guide
interface usb
6-51
Advertisement
Table of Contents
