Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
ip http cable-monitor
To enable the cable access router's onboard Cable Monitor web server, use the ip http cable-monitor
command in global configuration mode. To disable the Cable Monitor and turn off all access to the
onboard Cisco web server, use the no form of this command.
Cisco uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description
basic
advance
url-ip-address
url-mask
Defaults
For url-ip-address, 192.168.100.1
For url-mask, 255.255.255.0
Command Modes
Global configuration
Command History
Release
12.1(1)T
12.1(3)XL
12.1(5)XU1
12.2(2)XA
Usage Guidelines
This command enables the Cable Monitor, an onboard web server that displays current status,
troubleshooting, and performance information. The Cable Monitor can be accessed in two ways:
OL-1581-07
ip http cable-monitor {basic | advance} [url-ip-address url-mask]
no ip http cable-monitor
Displays only the basic status and performance pages.
Displays all status and diagnostic pages.
Note
(Optional) Specifies the IP address for the Cable Monitor. This argument,
along with the url-mask argument, also defines the network that provides
the IP address pool used by the temporary DHCP server when the cable
interface goes down.
(Optional) Specifies the subnet mask for the Cable Monitor. This argument,
along with the url-ip-address argument, also defines the network that
provides the IP address pool used by the temporary DHCP server when the
cable interface goes down.
Modification
This command is introduced for the Cisco uBR924 cable access router.
Support was added for the Cisco uBR905 cable access router.
Support was added for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
The Cable Monitor should not be used in advanced mode without
first implementing a secure password strategy on the cable access
router. Enabling the Cable Monitor in advanced mode without
setting an encrypted enabled password could provide information
that would allow remote users to change the router's configuration.
Cisco Broadband Cable Command Reference Guide
ip http cable-monitor
6-57
Advertisement
Table of Contents
