Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
Table 6-34 show voice port Field Descriptions (continued)
Field
Signal Type
Ring Frequency
Hook Status
Ring Active Status
Ring Ground Status
Tip Ground Status
Digit Duration Timing
InterDigit Duration Timing
InterDigit Pulse Duration
Timing
Alias
Coder Type
Hook Flash Duration Timing
Ring Cadence
In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the
Tip
exec prompt timestamp command in line configuration mode.
Related Commands
Command
show call active voice
show call history voice
show dial-peer voice
OL-1581-07
Description
Type of signalling for a voice port: loop-start, ground-start,
wink-start, immediate, and delay-dial.
Configured ring frequency for this interface.
Hook status of the FXO/FXS interface.
Ring active indication.
Ring ground indication.
Tip ground indication.
DTMF digit duration in milliseconds.
DTMF interdigit duration in milliseconds.
Pulse dialing interdigit timing in milliseconds.
User-supplied alias for this voice port, if any.
Voice compression mode used.
Maximum length of hook flash signal.
Configured ring cadence for this interface.
Description
Displays the contents of the active call table.
Displays the contents of the call history table.
Displays configuration information and call statistics for dial peers.
Cisco Broadband Cable Command Reference Guide
show voice port
6-179
Advertisement
Table of Contents
