Table of Contents
Advertisement
confreg
enabled are:
break/abort has effect
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
enable
enable
enable
enable
disable "break/abort has effect"? y/n
enable
change console baud rate? y/n
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
enabled are:
break/abort has effect
console baud: 9600
boot: image specified by the boot system commands
do you wish to change the configuration? y/n
rommon 2 >
Note
After changing the configuration register in interactive mode, the system displays the new values and
prompts you again as to whether you want to change them. If the values are correct, answer no and the
system returns you to the ROMMON prompt. If you made any changes, the system reminds you that you
must reset or power cycle the router before the new configuration register takes effect.
The following example shows how to set the configuration register to the typical value of 0x2102, so that
it boots a Cisco IOS software image:
rommon 7 > confreg 0x2102
rommon 8 >
Related Commands
Command
boot
Cisco Broadband Cable Command Reference Guide
A-16
Configuration Summary
"diagnostic mode"? y/n
"use net in IP bcast address"? y/n
"load rom after netboot fails"? y/n
"use all zero broadcast"? y/n
"ignore system config info"? y/n
[0]:
2
Configuration Summary
or default to: cisco2-C10000
You must reset or power cycle for new config to take effect.
You must reset or power cycle for new config to take effect.
Description
Boots the router manually.
[n]:
y
[n]:
[n]:
[n]:
[n]:
[n]:
[n]:
[n]:
[n]:
y
[n]: n
Appendix A
Using the ROM Monitor
OL-1581-07
Advertisement
Table of Contents
