Cisco SR2016T-NA Reference Manual page 1030

crypto ipsec client ezvpn xauth
crypto ipsec client ezvpn xauth
To respond to a pending VPN authorization request, use the crypto ipsec client ezvpn xauth command
in privileged EXEC mode.
Syntax Description
name
Defaults No default behavior or values
Command Modes
Privileged EXEC
Command History Release
12.2(4)YA
12.2(8)YJ, 12.2(15)T
Usage Guidelines
If the tunnel name is not specified, the authorization request is made on the active tunnel. If there is more
than one active tunnel, the command fails with an error requesting that you specify the tunnel name.
When making a VPN connection, individual users might also be required to provide authorization
information, such as a username or password. When the remote end requires this information, the router
displays a message on the router's console instructing the user to enter the crypto ipsec client ezvpn
xauth command. The user then uses the CLI to give this command and reply to the following prompts
to provide the required information.
If the user does not respond to the Authentication notification, the message is repeated every ten seconds.
Note
Examples The following example shows the user being prompted to enter the crypto ipsec client ezvpn xauth
command. The user then enters the requested information and continues.
Router#
20:27:39: EZVPN: Pending XAuth Request, Please enter the following command:
20:27:39: EZVPN: crypto ipsec client ezvpn xauth
Router# crypto ipsec client ezvpn xauth
Enter Username and Password: userid
Password: ************
Router#
Cisco Broadband Cable Command Reference Guide
6-28
crypto ipsec client ezvpn xauth name
Identifies the IPSec VPN tunnel with a unique, arbitrary name.
Modification
This command was introduced on Cisco 806, Cisco 826, Cisco 827, and
Cisco 828 routers; Cisco 1700 series routers; and Cisco uBR905 and
Cisco uBR925 cable access routers.
The name option was added as a required argument to specify a specific
IPSec VPN tunnel.
Chapter 6 Cable CPE Commands
OL-1581-07