Default Snmp Configuration; Enabling The Snmp Agent - Cisco M10-RM Software Manual

Chapter 18 Configuring SNMP
Configuring SNMP
This section describes how to configure SNMP on your access point. It contains this configuration
information:
•
•
•
•
•
•
•
•
•
•

Default SNMP Configuration

Table 18-3
Table 18-3
Feature
SNMP agent
SNMP community strings
SNMP trap receiver
SNMP traps

Enabling the SNMP Agent

No specific CLI command exists to enable SNMP. The first snmp-server global configuration command
that you enter enables the supported versions of SNMP.
You can also enable SNMP on the SNMP Properties page on the web-browser interface. When you
enable SNMP on the web-browser interface, the access point automatically creates a community string
called public with read-only access to the IEEE802dot11 MIB.
OL-14209-01
Default SNMP Configuration, page 18-5
Enabling the SNMP Agent, page 18-5
Configuring Community Strings, page 18-6
Specifying SNMP-Server Group Names, page 18-7
Configuring SNMP-Server Hosts, page 18-8
Configuring SNMP-Server Users, page 18-8
Configuring Trap Managers and Enabling Traps, page 18-8
Setting the Agent Contact and Location Information, page 18-10
Using the snmp-server view Command, page 18-10
SNMP Examples, page 18-10
shows the default SNMP configuration.
Default SNMP Configuration
Default Setting
Disabled
No strings are configured by default. However,
when you enable SNMP using the web-browser
interface, the access point automatically creates
the public community with read-only access to the
IEEE802dot11 MIB.
None configured
None enabled
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring SNMP
18-5