Local Authenticator Messages - Cisco M10-RM Software Manual

Appendix C Error and Event Messages

Local Authenticator Messages

Error Message RADSRV-4-NAS_UNKNOWN: Unknown authenticator: [ip-address]
Error Message RADSRV-4-NAS_KEYMIS: NAS shared key mismatch.
Error Message RADSRV-4_BLOCKED: Client blocked due to repeated failed
authentications
Error Message
Error Message DOT1X-SHIM-6-AUTH_OK: "Interface %s authenticated [%s]."
Error Message DOT1X-SHIM-3-AUTH_FAIL: "Interface %s authentication failed."
Error Message DOT1X-SHIM-3-INIT_FAIL: "Unable to init - %s."
OL-14209-01
Explanation The local RADIUS server received an authentication request but does not recognize the
IP address of the network access server (NAS) that forwarded the request.
Make sure that every access point on your wireless LAN is configured as a
Recommended Action
NAS on your local RADIUS server.
The local RADIUS server received an authentication request but the message signature
Explanation
indicates that the shared key text does not match.
Recommended Action Correct the shared key configuration on either the NAS or on the local
RADIUS server.
A user failed authentication the number of times configured to trigger a block, and the
Explanation
account been disabled.
Recommended Action Use the clear radius local-server user username privileged EXEC command
to unblock the user, or allow the block on the user to expire by the configured lockout time.
Explanation The 802.1x authentication was successful.
None
Recommended Action
Explanation The 802.1x authentication failed to the attached device.
Check the configuration of the 802.1x credentials on the client as well as the
Recommended Action
RADIUS server.
Explanation An error occurred during the initialization of the shim layer.
Recommended Action
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Local Authenticator Messages
C-21