Using Debug Messages; Configuring Fast Secure Roaming; Requirements For Fast Secure Roaming - Cisco M10-RM Software Manual

Chapter 12 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services

Using Debug Messages

In privileged exec mode, use these debug commands to control the display of debug messages for devices
interacting with the WDS device:
Command
debug wlccp ap
{mn | wds-discovery | state}
debug wlccp dump
debug wlccp packet
debug wlccp wds [aggregator |
authenticator | nm | state |
statistics]
debug wlccp wds authenticator
{all | dispatcher | mac-authen |
process | rxdata | state-machine |
txdata}

Configuring Fast Secure Roaming

After you configure WDS, access points configured for CCKM can provide fast, secure roaming for
associated client devices. This section describes how to configure fast, secure roaming on your wireless
LAN. This section contains these sections:
•
•

Requirements for Fast Secure Roaming

To configure fast secure roaming, you must have these items on your wireless LAN:
•
•
•
•
•
For instructions on configuring WDS, refer to the
OL-14209-01
Requirements for Fast Secure Roaming
Configuring Access Points to Support Fast Secure Roaming
At least one access point, ISR, or switch (equipped with a WLSM) configured as the WDS device
Access points configured to participate in WDS
Access points configured for fast, secure roaming
An authentication server (or an access point, ISR, or switch configured as a local authenticator)
Cisco Aironet client devices, or Cisco-compatible client devices that comply with Cisco Compatible
Extensions (CCX) version 2 or later
Description
Use this command to turn on display of debug messages related
to client devices (mn), the WDS discovery process, and access
point authentication to the WDS device (state).
Use this command to perform a dump of WLCCP packets
received and sent in binary format.
Use this command to turn on display of packets to and from the
WDS device.
Use this command and its options to turn on display of WDS
debug messages. Use the statistics option to turn on display of
failure statistics.
Use this command and its options to turn on display of WDS
debug messages related to authentication.
"Configuring WDS" section on page
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring Fast Secure Roaming
12-7.
12-21