Appendix C Error And Event Message; Software Auto Upgrade Messages - Cisco M10-RM Software Manual

Appendix C Error and Event Messages

Software Auto Upgrade Messages

Error Message SW-AUTO-UPGRADE-2-FATAL_FAILURE: "Attempt to upgrade software failed,
software on flash may be deleted. Please copy software into flash.
Error Message SW-AUTO-UPGRADE-7-DHCP_CLIENT_FAILURE: "%s": Auto upgrade of the
software failed."
Error Message SW-AUTO-UPGRADE-7-DHCP_SERVER_FAILURE: "%s": Auto upgrade of the
software failed."
Error Message SW-AUTO-UPGRADE-7_BOOT_FAILURE: "%s": Auto upgrade of the software
failed."
Error Message DOT11-4-UPGRADE: "Send your company name and the following report to
migrateapj52w52@cisco.com." The following AP has been migrated from J(j52) to
U(w52) Regulatory Domain:AP name AP Model Ethernet MAC %s %s %e \U\Regulatory Doman
Error Message AUTO-INSTALL-4-STATION_ROLE: "%s": The radio is operating in automatic
install mode."
OL-14209-01
Auto upgrade of the software failed. The software on the flash might have been deleted.
Explanation
Copy software into the flash.
Copy software before rebooting the unit.
Recommended Action
Auto upgrade of the software failed.
Explanation
Make sure that the DHCP client is running.
Recommended Action
Auto upgrade of the software failed.
Explanation
Recommended Action Make sure that the DHCP server is configured correctly.
Auto upgrade of the software failed.
Explanation
Reboot the unit. If the message appears again, copy the error message exactly
Recommended Action
as it appears and report it to your technical support representative.
A Japan regulatory domain field upgrade from J to U has been accomplished.
Explanation
None
Recommended Action
The radio is operating in automatic install mode.
Explanation
Use the station-role configuration interface command to configure the radio
Recommended Action
for a role other than install mode.
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Software Auto Upgrade Messages
C-3