Cisco M10-RM Software Manual page 21

Preface
Audience
This guide is for the networking professional who installs and manages Cisco Aironet Access Points. To
use this guide, you should have experience working with the Cisco IOS software and be familiar with
the concepts and terminology of wireless local area networks.
The guide covers two Cisco IOS releases: 12.4(10b)JA and 12.3(8)JEC. Cisco IOS Release 12.4(10b)JA
supports the following autonomous 32 Mb platforms:
•
•
•
•
Cisco IOS Release 12.3(8)JEC is a maintenance release and supports the following autonomous 16 Mb
platforms:
•
•
•
Note This guide does not cover lightweight access points. Configuration for these devices can be found in the
appropriate installation and configuration guides on cisco.com.
Purpose
This guide provides the information you need to install and configure your access point. This guide
provides procedures for using the Cisco IOS software commands that have been created or changed for
use with the access point. It does not provide detailed information about these commands. For detailed
information about these commands, refer to the Cisco IOS Command Reference for Cisco Aironet Access
Points and Bridges for this release. For information about the standard Cisco IOS software commands,
refer to the Cisco IOS software documentation set available from the Cisco.com home page at Support
> Documentation. On the Cisco Support Documentation home page, select Release 12.4 from the Cisco
IOS Software drop-down list. Select wireless in the left frame to view the Wireless Support Resources
page, then navigate to the access point or bridge for you are using.
OL-14209-01
1130 series access point
1240 series access point
1250 series access point
1300 outdoor access point/bridge
1100 series access point
1200 series access point
1230 series access point
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
xix