Indicators On 1300 Outdoor Access Point/Bridges; Normal Mode Led Indications - Cisco M10-RM Software Manual

Checking the Top Panel Indicators

Indicators on 1300 Outdoor Access Point/Bridges

If your access point/bridge is not associating with a remote bridge or access point, check the four LEDs
on the back panel. You can use them to quickly assess the unit's status. For information on using the
LEDs during the installation and alignment of the access point/bridge antenna, refer to the Cisco Aironet
1300 Series Outdoor Access Point/Bridge Mounting Instructions that shipped with your access
point/bridge.
Figure 22-8
Figure 22-8
R
S

Normal Mode LED Indications

During access point/bridge operation the LEDs provide status information as shown in
Table 22-5 1300 Series Access Point/Bridge LED Indications
Ethernet Status
LED LED
Off —
Blinking —
green
Blinking —
amber
amber —
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
22-14
shows the access point/bridge LEDs.
LEDs
R S E
I
Radio LED
Status LED
Radio Install
LED LED
— —
— —
— —
— —
E Ethernet LED
I Install LED
Meaning
Ethernet link is down or disabled.
Transmitting and receiving Ethernet packets.
Transmitting and receiving Ethernet errors.
Firmware error—disconnect and reconnect the power injector power
jack. If the problem continues, contact technical support for
assistance.
Chapter 22 Wireless Device Troubleshooting
Table 22-5.
OL-14209-01