Wds Messages - Cisco M10-RM Software Manual

Appendix C Error and Event Messages

WDS Messages

Error Message WLCCP-WDS-6-REPEATER_STOP: WLCCP WDS on Repeater unsupported, WDS is
disabled.
Error Message WLCCP-WDS-6-PREV_VER_AP: A previous version of AP is detected.
Error Message WLCCP-AP-6-INFRA: WLCCP Infrastructure Authenticated
Error Message WLCCP-AP-6-STAND_ALONE: Connection lost to WLCCP server, changing to
Stand-Alone Mode
Error Message WLCCP-AP-6-PREV_VER_WDS: A previous version of WDS is detected
Error Message WLCCP-AP-6-UNSUP_VER_WDS: An unsupported version of WDS is detected
OL-14209-01
out before trying the next configured server. A Radius server marked as dead is skipped by
additional requests for the duration of the minutes unless all servers are marked dead. Configuring
dead time for 10 minutes means that the server cannot be used for 10 minutes.
You can disable this command if you want this log to disappear. Actually this
Recommended Action
message is not really a major problem, it is just an informational log.
Repeater access points do not support WDS.
Explanation
None.
Recommended Action
The WDS device detected a previous version of the access point.
Explanation
None.
Recommended Action
The access point successfully authenticated to the WDS device.
Explanation
None.
Recommended Action
The access point lost its connection to the WDS device and is in stand-alone mode.
Explanation
Recommended Action None.
The access point detected a previous version of WDS.
Explanation
Recommended Action Check for an unsupported version of WDS on your network.
The access point detected an unsupported version of WDS.
Explanation
Check for an unsupported version of WDS on your network.
Recommended Action
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
WDS Messages
C-23