Cisco M10-RM Software Manual page 440

Checking the Top Panel Indicators
Figure 22-4
The indicator signals on the wireless device have the following meanings (for additional details refer to
Table
The Ethernet indicator signals traffic on the wired LAN. This indicator is normally green when an
•
Ethernet cable is connected, and blinks green when a packet is received or transmitted over the
Ethernet infrastructure. The indicator is off when the Ethernet cable is not connected.
The status indicator signals operational status. Steady green indicates that the wireless device is
•
associated with at least one wireless client. Blinking green indicates that the wireless device is
operating normally but is not associated with any wireless devices.
The radio indicator blinks green to indicate radio traffic activity. The light is normally off, but it
•
blinks whenever a packet is received or transmitted over the wireless device's radio.
Table 22-1
Message
type
Boot loader
status
Association
status
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
22-4
Indicators on the 350 Series Access Point (Metal Case)
CISCO AIRONET 350
W I R E L E S S A C C E S S P O I N T
22-1):
Top Panel Indicator Signals
Ethernet
indicator
Green
–
–
Amber
Green
–
–
SERIES
ETHERNET ACTIVITY
ASSOCIATION STATUS
RADIO ACTIVITY
Status Radio
indicator indicator
– Green
Amber Red
Blinking Blinking
green green
Green –
Green Green
Green –
Blinking –
green
Chapter 22 Wireless Device Troubleshooting
Ethernet
Status
Radio
Meaning
DRAM memory test.
Board initialization test.
Flash memory test.
Ethernet initialization test.
Starting Cisco IOS software.
At least one wireless client device is
associated with the unit.
No client devices are associated; check the
wireless device's SSID and WEP settings.
OL-14209-01