Configuring Repeater And Standby Access Points And Workgroup Bridge Mode - Cisco M10-RM Software Manual

Configuring Repeater and Standby Access Points
and Workgroup Bridge Mode
This chapter describes how to configure your access point as a repeater, as a hot standby unit, or as a
workgroup bridge. This chapter contains these sections:
• Understanding Repeater Access Points, page 19-2
Configuring a Repeater Access Point, page 19-3
•
Understanding Hot Standby, page 19-9
•
Configuring a Hot Standby Access Point, page 19-9
•
Understanding Workgroup Bridge Mode, page 19-13
•
Configuring Workgroup Bridge Mode, page 19-16
•
The Workgroup Bridge in a Lightweight Environment, page 19-18
•
OL-14209-01
C H A P T E R
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
19
19-1