Table of Contents
Advertisement
6.7.5. SNMP configuration
The SNMP window can be used to configure an SNMP v2c or SNMP v3
service to run on the Cisco FM1000 Gateway.
Walk-throughs (no agent-to-manager notifications) and traps (agent-to-
manager notifications enabled) are both supported. If SNMP traps are
enabled, you can specify the server address to which monitoring
information must be sent.
IMPORTANT
The same SNMP configuration must be set for all Fluidmesh
units in the wireless network.
For
configuration, refer to the Fluidmesh SNMP FM-MIB OID Table
and MIB configuration files. These can be downloaded from
the Fluidmesh Partner Portal (Documentation section > User
Manuals > Advanced Manuals.)
To change the SNMP settings, do the following steps:
•
Click the -snmp mode link under ADVANCED SETTINGS in the
left-hand settings menu.
• The default SNMP dialog will be shown
77)).
Figure 34. SNMP dialog (SNMP disabled)
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
5.255.255.255 is the wildcard address for all Mesh ID
destinations within the network.
detailed
information
on
NOTE
By default, Fluidmesh units are shipped from the
factory with SNMP disabled.
Fluidmesh
unit
SNMP
(Figure 34 (page
Page 77 of 138
Advertisement
Table of Contents
