Ignoring The Ccx Neighbor List; Configuring A Client Vlan; Configuring Workgroup Bridge Mode - Cisco M10-RM Software Manual

Configuring Workgroup Bridge Mode

The following example shows how the command is used. In the example, channels 1, 6, and 11 are
specified to scan:
ap#
ap#confure terminal
Enter configuration commands, one per line.
ap(config)#int d0
ap(config-if)#ssid limited_scan
ap(config-if)#station-role workgroup-bridge
ap(config-if)#mobile station
ap(config-if)#mobile station scan 1 6 11
ap(config-if)#end
ap#
Use the no mobile station scan command to restore scanning to all the channels.

Ignoring the CCX Neighbor List

In addition, the workgroup bridge updates its known channel list using CCX reports such as the AP
Adjacent report or Enhanced Neighbor List report. However, when a workgroup bridge is configured for
limited channel scanning, it does not need to process the CCX reports to update its known channel list.
Use the mobile station ignore neighbor-list command to disable processing of CCX neighbor list
reports. This command is effective only if the workgroup bridge is configured for limited scanning
channel scanning. The following example shows how this command is used
ap#
ap#confure terminal
Enter configuration commands, one per line.
ap(config)#int d0
ap(config-if)#mobile station ignore neighbor-list
ap(config-if)#end

Configuring a Client VLAN

If the devices connected to the workgroup bridge's Ethernet port should all be assigned to a particular
VLAN, you can configure a VLAN for the connected devices. Enter this command on the workgroup
bridge:
ap(config)# workgroup-bridge client-vlan vlan-id
All the devices connected to the workgroup bridge's Ethernet port are assigned to that VLAN.
Configuring Workgroup Bridge Mode
Beginning in privileged EXEC mode, follow these steps to configure an access point as a workgroup
bridge:
Command
Step 1
configure terminal
Step 2 interface dot11radio {0 | 1}
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
19-16
Chapter 19 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
End with CNTL/Z.
End with CNTL/Z.
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface.
OL-14209-01