Table of Contents
Advertisement
FCC Notification
and Repair Information
This equipment is registered with the Federal Communications Commission
(FCC) in accordance with Part 68 of its rules. In compliance with those rules,
you are advised of the following:
MEANS OF CONNECTION: Connection to the telephone network shall be
through a standard network interface jack USOC RJ11C. These USOCs must
be ordered from your Telephone Company.
This equipment may not be used with party lines or coin telephone lines.
NOTIFICATION TO THE TELEPHONE COMPANIES: Before connecting this
equipment, you or your equipment supplier must notify your local telephone
company's business office of the following:
The telephone numbers you will be using with this equipment.
The appropriate registration number and ringer equivalence number
(REN) which can be found on the back or bottom of the control unit.
You must also notify your local telephone company if and when this
equipment is permanently disconnected from the line(s).
Repair Instructions: If you experience trouble because your equipment is
malfunctioning, the FCC requires that the equipment not be used and that it
be disconnected from the network until the problem has been corrected.
Repairs to this equipment can only be made by the manufacturers, their
authorized agents, or by others who may be authorized by the FCC. [In the
event repairs are needed on this equipment, please contact the AT&T
National Service Assistance Center (NSAC) at 1 800 628-2888.]
Rights of the Local Telephone Company: If this equipment causes harm to
the telephone network, the local telephone company may discontinue your
service temporarily. If possible, they will notify you in advance. But if
advance notice is not practical, you will be notified as soon as possible. You
will also be informed of your right to file a complaint with the FCC.
Advertisement
Table of Contents
