AT&T Call Management System Installation And Programming Manual page 139

Troubleshooting
Possible Cause
Printer is not in "on-line" or
"ready" status.
The printer is not receiving
power.
The printer has no paper,
or the paper is jammed.
A cable connection
between the printer and
the PC is loose.
NOTE:
If the problem is corrected, you should see the message
Printer Now Ready
If you do not see this message, try correcting the problem again. If you still
do not see the message, reboot the PC and restart CMS. If the problems
persists, call NTSC/NSAC at the phone numbers listed on the inside front
cover of this guide or contact your AT&T Authorized Dealer.
Corrective Action
Put printer in "on-line" or "ready" status.
Make sure the printer is plugged in and turned
on, and the Ready light is on.
1. Make sure paper is loaded and that the
paper isn't jammed.
2. Make sure the paper is aligned properly.
3. Press the Form Feed button on the
printer to make sure the paper feeds
properly.
Make sure the connections are secure at both
ends of the cable running between the printer
and the PC.
Warning Messages
9-13