AT&T Call Management System Installation And Programming Manual page 143

Troubleshooting
NOTE:
If the problem is corrected, you should see the message
Printer Now Ready
If you do not see this message, try correcting the problem again. If you still
do not see the message, reboot the PC and restart CMS. If the problems
persists, call NTSC/NSAC at 1 800 628-2888 or your AT&T Authorized Dealer.
REPORT ABORTED--Printer Not Ready.
Possible Cause
The printer has no paper,
or the paper is jammed.
Corrective Action
1. Make sure paper is loaded in the printer
and the paper isn't jammed.
2. Press the Form Feed button on the
printer to make sure the paper feeds
properly.
3. When the printer is ready, repeat your
print request.
Other Messages
9-17