Table of Contents
Advertisement
To set ranges and values for dynamic IP addressing when only using
a 30-Port IP Board:
1.
In the G711 IP Ranges list, click the Add button. The Add IP Codec
Setting dialog appears.
Figure 6. Add IP Codec Setting
2.
In the Add IP Codec Setting dialog, specify Range to set a range of
dynamic IP address.
3.
Enter the Start value as 0.0.0.1; for the End value, enter
255.255.255.254.
You cannot use the minimum and maximum values (0.0.0.0. and
255.255.255.255).
4.
Click OK.
5.
From the main menu, go to the VoIP Codec Configuration window
and change the codec setting of current selection of all servers and
codecs to G.711 uLaw, then click OK. (By default, server codec is set
to G.723.1.)
This will force all connections to be G.711 and allow remote users
access to a range of IP addresses, instead of the users having to contact
the administrator for the specific IP address.
IP and Physical Extension Login/Logoff Interaction
When an IP extension associated with a physical extension logs in, the
physical extension is disabled. When the IP extension logs off, the physical
extension is automatically enabled.
While the IP extension is logged in, the user can activate the physical
extension on a phone using the #27 feature code. This logs off the IP
extension.
AltiWare OE System Installation & Administration Manual
Extension and Group Configuration
10-15
Advertisement
Table of Contents
Troubleshooting
