Table of Contents
Advertisement
Synchronizing E-mail with Exchange
Parameter
Synchronize with
Exchange Server
Defining an IP Dialing Table
To use an AltiServ-to-AltiServ connection for voiceover IP, you need to
configure the routing in the IP Dialing Table for each AltiServ system.
Note:
To enable VoIP, you must have at least one Triton VoIP board
installed and configured. (The IP Dialing Table is disabled unless
there is at least one VoIP board installed.) You also must have
assigned an IP Trunk Access code, as discussed in "Assigning
Trunk, Feature, IP Trunk, & Route Access" on page 5-9, and you
must set the VoIP codecs as discussed in "Setting VoIP Codecs"
on page 10-12.
About the Location ID Digit Length
In the IP dialing table, you define the addresses of the remote locations and
set a Location ID Digit Length. The dialing length sets the length of the
Location ID, the number you define in the dialing table to identify each
remote location.
The Location ID is used in dialing: the user dials the IP trunk access,
followed by the location ID to identify the remote location, followed by the
remote extension. For example, if the IP trunk access is 8, the location ID
is 27, and the extension to reach is 837, the user dials 8 27 837.
AltiWare OE System Installation & Administration Manual
Description
Before selecting this option to use an Exchange
Server, you should make sure the Exchange Server
and Windows / NT configuration is established. See
the AltiGen document, Exchange Server Integration
in AltiWare OE.
Select this option if you are using an Exchange
Server and want to synchronize it and the AltiServ
servers—that is, when emails or voice mails are
deleted from one service, they are automatically
deleted from the other server as well.
If you choose this option, you must type in the
Exchange Server Address. The name must be just the
name of the machine or the fully qualified domain
name.
System Configuration
5-27
Advertisement
Table of Contents
Troubleshooting
