Table of Contents
Advertisement
Adding a Dialing Pattern Definition
1. Click Add to open the Add an entry dialog box.
2. Type in a Prefix number, select the pattern length, then click OK.
Note:
The pattern length tells the system to wait for n number of digits to
be dialed before executing the route or disallowing the call.
Selecting N/A creates a '?' symbol in place of number of the digits,
and this indicates an unspecified number of digits.
After a route is added, you can edit to further define it as described in the
following discussion.
Editing a Dialing Pattern
To edit, or define, a pattern, select and highlight the route in the prefix list,
make changes to the attributes, then click Apply.
You can change the following attributes:
•
Prefix and Pattern length. If desired, you can change the prefix
number and pattern length for a prefix.
•
Disallow this dialing pattern check box. Select this to block calls that
match the dialing pattern.
•
Route Priority boxes. These specify the trunk route(s) and the order
of routes assigned to the prefix. Use the drop-down list to select the
desired route used when the selected dialing pattern is found. Up to six
routes can be assigned, and they are accessed in order from 1–6.
Note: The SIP Redirect Server fields are reserved for future use.
Deleting a Pattern
To delete a pattern, highlight the one you want to delete in the prefix list,
then click Delete.
AltiWare OE System Installation & Administration Manual
Out Call Routing Configuration
8-7
Advertisement
Table of Contents
Troubleshooting
