Holder, Shaft Unit Removal - Epson R200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R200/R210

2.3.8 Holder, Shaft Unit removal

o
External View
Hook
Backside
2
C.B.S 3x6 (6-8kgf/cm)
Dowel
Shield Plate, FFC
Hook
Hook
Head FFC
1
Hook
Figure 2-13. "Holder, Shaft Unit" removal (1)
DISASSEMBLY AND ASSEMBLY
CN7, CN8, CN15
Board, Main
CN9
CN5
C.B.S 3x6 (6-8kgf/cm)
PE sensor
Right front side
1
Hook
o
Parts/Units which should be removed before removing "Holder, Shaft Unit"
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Assy.
o
Disassembly Procedure
n
Holder, Shaft Unit removal
1. Release the following connector cables from "Board, Main".
CN5 : CR motor connector cable
CN7 : Head FFC
CN8 : Head FFC
CN9 : PE sensor connector cable
CN15 : CSIC/CR encoder/PW sensor FFC
2. Release the CR motor connector cable from "Holder, Shaft Unit".
3. Move "Carriage Unit" to the left side of the printer.
4. Remove the screws (x2) for securing "Holder, Shaft Unit".
5. Release the Head FFC with "Shield Plate, FFC" from "Holder, Shaft Unit".
o
Do not use "Shield Plate, FFC" again if you peel it off.
o
Do not damage "Shield Plate, FFC".
o
Do not damage "Cable, Head".
6. Release the hooks (
Shaft Unit" upward, and release the dowel (
7. Looking at the printer from its back side, press down "Paper Guide, Upper" on
the left, and release "PE Sensor Lever" from the slot. Then, remove "Holder,
Shaft Assy." by sliding it to the right.
Be careful not to damage "PE Sensor Lever" and "Paper Guide,
Upper" when removing them since "PE Sensor Lever" contacts
with "Paper Guide, Upper".
Disassembly
1
: x2) with the tweezers or alike while pulling"Holder,
2
: x1) from "Ink System Frame".
Revision A
46