Epson R200 - Stylus Photo Color Inkjet Printer Service Manual page 23

EPSON Stylus Photo R200/R210
Occurrence Timing
Phenomenon Detail
Position of CR
"CR Motor" does not work at all when
turning on the power.
"Carriage Unit" strikes on "Lever,
Change" which is leaning forward when
turning on the power.
At power-on
Out of HP
"Carriage Unit" strikes on "Paper Guide,
Upper" which has come off from "Main
Frame" when turning on the power.
"Carriage Unit" strikes on the right side
At power-on
of "Main Frame" when turning on the
Anywhere
power.
TROUBLESHOOTING
Table 1-10. Check Points for Fatal Error to Each Phenomenon
Faulty Part/
Part Name
1. Check if "CR Motor Connector Cable" is connected to
CN5 on "Main Board".
CR Motor
2. Check if "CR Motor Connector Cable" is not damaged.
1. Check if "PF Motor Connector Cable" is connected to
CN6 on "Main Board".
PF Motor 2. Check if the resistance of "PF Motor" is approximately
3.0W using a tester. Refer to Table 1-1.
3. Check if "PF Motor Connector Cable" is not damaged.
1. Check if "Compression Spring, 2.36" of "Lever, Change"
has not come off.
Ink System
Compression Spring, 2.36
1. Check if "Paper Guide, Upper" has not come off from
"Main Frame".
Paper Guide,
Upper
1. Check if "CR Scale" has not come off or it properly
passes through the slit of "CR Encoder Sensor Board".
CR Scale
Unit Level Troubleshooting
Check Point
1. Connect "CR Motor Connector Cable" to
2. Replace "CR Motor" with a new one.
1. Connect "PF Motor Connector Cable" to CN6
2. Replace "PF Motor" with a new one.
3. Replace "PF Motor" with a new one.
1. Replace "Ink System" with a new one.
Lever, Change
1. Reassemble "Paper Guide, Upper" to "Main
Paper Guide, Upper
1. Reassemble "CR Scale" correctly.
Revision A
Remedy
CN5 on "Main Board".
on "Main Board".
Frame".
* If the problem is not solved, replace
"Main Board" with a new one.
23