Cr Motor Removal - Epson R200 - Stylus Photo Color Inkjet Printer Service Manual

Color inkjet printer
Hide thumbs Also See for R200 - Stylus Photo Color Inkjet Printer:
Table of Contents

Advertisement

EPSON Stylus Photo R200/R210

2.3.4 CR Motor removal

o
External View
Hook
Backside
CR Motor
Puller, Driven
Timing Belt
Figure 2-8. CR Motor removal
o
Parts/Units which should be removed before removing "CR Motor"
Paper Support Assy./Housing (left/right)/Housing (frame)
DISASSEMBLY AND ASSEMBLY
o
CN5
C.C 3x4 (3.5-4.5kgf•cm)
1
2
CR Motor
Disassembly
Disassembly Procedure
1.
Disconnect the CR motor connector cable from the connector (CN5) of
"Board, Main".
2.
Release the CR motor connector cable from the "Holder, Shaft Unit".
3.
Release the carriage lock with the tweezers or alike, then move "Carriage
Unit" to the centre of the printer.
4.
Push "Pulley, Driven" in the direction of the arrow and loosen the tension of
"Timing Belt". Then, remove "Timing Belt" from the pinion gear of "CR
Motor".
5.
Remove the screws (x2) which secure "CR Motor", and remove "CR Motor".
Do not damage the pinion gear when removing "CR Motor".
o
When reinstalling the "CR Motor",
n
Make sure to screw "CR Motor" in the order as shown in
the figure.
n
Make sure that there is no gap between "CR Motor" and
"Frame, Main".
n
Make sure that the part on which "CR Motor" Lot number
is printed is face-up.
o
When having removed or replaced "CR Motor", implement the
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
1.
First dot Adjustment
2.
PW Sensor Adjustment
3.
Head Angular Adjustment
4.
Bi-D Adjustment
5.
Offset Input for CR Motor Calorific Limitation (When
Replaced)
Revision A
42

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stylus photo r210

Table of Contents