Epson R200 - Stylus Photo Color Inkjet Printer Service Manual page 25

EPSON Stylus Photo R200/R210
Occurrence Timing
Phenomenon Detail
Position of CR
[Phenomenon 1]
When the printer is performing the
Cleaning task, the ink is not drained into
"Waste Ink Pad" in spite of the correct
function of "Pump Unit".
The ink is not absorbed from "Print
Head" to the Cap at all.
[Phenomenon 2]
When the printer is performing the
Cleaning task, the ink is drained into
"Waste Ink Pad". (This indicates that
both of "Pump Unit" and "Cap Unit" are
working correctly.) However, missing
dots is not solved at certain nozzles even
performing the Cleaning several times.
[Phenomenon 3]
When the printer is performing the
At operation
Cleaning task, the ink is drained into
-
"Waste Ink Pad". (This indicates that
both of "Pump Unit" and "Cap Unit"
work correctly.) However, the wiping
function is not executed correctly and
some different colors of ink mix
together.
[Phenomenon 4]
When the printer is performing the
Cleaning task, the ink is drained into
"Waste Ink Pad". However, some
missing dots occurs while printing.
[Phenomenon 5]
When the printer is performing the
Cleaning task, the ink is drained into
"Waste Ink Pad". However, missing dot
occurs and the points where it occurs
varies in every movement of the
Cleaning.
TROUBLESHOOTING
Table 1-13. Check Points for Defective Print Quality
Faulty Part/
Check Point
Part Name
1. Check if there is not any foreign matter on the sealing
rubber on "Cap Unit".
2. Check if the sealing rubber on "Cap Unit" is not damaged.
3. Check if "Compression Spring, 2.53" is properly attached
in "Cap Unit".
4. Check if "Pump Tube" is properly connected to the
bottom of "Cap Unit".
Ink System
Contact point of
Pump Tube
5. Check if "Extension Spring, 0.788" has not come off from
"Slider Cap".
6. Check if "Extension Spring, 0.441" has not come off from
"Slider Cap".
Extension Spring, 0.788
Unit Level Troubleshooting
1. Remove the foreign matter from the sealing
rubber.
Sealing rubber
2. Replace "Ink System" with a new one.
3. Replace "Ink System" with a new one.
Compression
Spring, 2.53
4. Replace "Ink System" with a new one.
5. Reassemble "Extension Spring, 0.788"
correctly.
6. Reassemble "Extension Spring, 0.441"
correctly.
Extension Spring, 0.441
Revision A
Remedy
25