Epson R200 - Stylus Photo Color Inkjet Printer Service Manual page 53

EPSON Stylus Photo R200/R210
o
External View (Cont.)
Bushing, Parallel C.P.S (P4) 3x6
Adjust, Right (6-8kgf•cm)
CR Encoder
CSIC Board
Sensor Board Connector
Hooks
Holder Pad, Ring
Oil Pad, Ring
Extension Spring, 26.46
Pulley, Driven
2
1
Figure 2-24. "Carriage Unit" removal (3)
DISASSEMBLY AND ASSEMBLY
C.P.B (P1) 1.7x5
Holder, FFC ; B
(1.5-2.5kgf•cm)
Timing Belt
Hooks
CR Encoder Sensor Board PW Sensor FFC
C.P.B (P1) 1.7x5
Connector Slot
(1.5-2.5kgf•cm)
Disassembly
16. Remove the screw (x1) for securing "Bushing, Parallel Adjust, Left". Then,
remove "Bushing, Parallel Adjust, Left".
17. Remove "Timing Belt" from "Carriage Unit".
18. Remove the screws (x2) for securing "Holder, FFC; B". Then, remove
"Holder, FFC; B".
19. Remove "Cable, Head" from the connectors of "CSIC Board" and "CR
Encoder Sensor Board". Then, remove "Cable Head" from "Carriage Unit".
20. Release the hooks (x2) from "Holder Pad, Ring" (x2). Then, remove "Holder
Pad, Ring" (x2) and "Oil Pad, Ring" (x2).
n
"Pulley, Driven" removal
1. Remove "Extension Spring, 26.4 6" from "Pulley Driven" and the hook of
"Frame, Main" by using a flat-blade screwdriver. Then, remove "Extension
Spring, 26.46".
2. Slide "Pulley, Driven" in the direction of the arrow. Then, remove "Frame,
Main" from the slot.
n
"CR Encoder Sensor Board" removal
1. Remove the screw which secures "CR Encoder Sensor Board" with Phillips
screwdriver (No.0). Disconnect "PW Sensor FFC" from the connector of "CR
Encoder Sensor Board". Then, remove "CR Encoder Sensor Board".
Revision A
53