Porous Pad, Paper Guide, Front Removal - Epson R200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R200/R210

2.3.6 Porous Pad, Paper Guide, Front removal

o
External View
Porous Pad, Paper Guide, Front, Left Porous Pad, Paper Guide, Front, Left
Porous Pad, Paper Guide, Front, Support
Figure 2-10. "Porous Pad, Paper Guide, Front" removal
o
Pars/Units which should be removed before removing "Porous Pad, Paper
Guide, Front"
Paper Support Assy./Housing (left/right)/Housing (frame)
o
Disassembly Procedure
1. Remove the following 3 types of porous pads from "Paper Guide, Front" by
using the tweezers.
• Porous Pad, Paper Guide, Front
• Porous Pad, Paper Guide, Front, Support
• Porous Pad, Paper Guide, Front, Left
Make sure to take "Porous Pad, Paper Guide, Front" cleanly as it
is glued.
DISASSEMBLY AND ASSEMBLY
Porous Pad, Paper Guide, Front
Folding Points
Disassembly
Vertical Direction: 4 ± 1mm
Horizontal Direction: 1-2mm
Vertical Direction: 4 ± 1mm
Horizontal Direction: 2-3mm
Figure 2-11. Gluing Point of "Porous Pad, Paper Guide, Front"
o
When reinstalling "Porous Pad, Paper Guide, Front"/"Porous
Pad, Paper Guide, Front, Support"
n
Fold perpendicularly left and right sides of "Porous Pad,
Paper Guide, Front, Support" at the marks and install it to
"Paper Guide, Front". Make sure that the slit engages with
the rib located on the side of "Paper Guide, Front" so that
they will fit securely.
n
Apply ThreeBond 1401 to the 6 points shown in the figure
above.
n
Install "Porous Pad, Paper Guide, Front" in piles. Put it
under the rib, and check if it is securely fit. Adjust the
clearance between "Porous Pad, Paper Guide, Front" and
"Paper Guide, Front" approximately in 0.5 - 1.0mm.
o
When reinstalling "Porous Pad, Paper Guide, Front, Support"
n
Insert the foot-parts into the holes of "Paper Guide, Front".
Then, put them under the rib and check if it is securely fit.
o
Do not damage "Porous Pad, Paper Guide, Front, Support".
o
Do not apply too much adhesive when using some. Do not
contaminate "Porous Pad, Paper Guide, Front, Support" with
the adhesive.
o
Install "Porous Pad, Paper Guide, Front" immediately after
applying the adhesive.
o
Make sure that the 3 porous pads are fit securely.
Revision A
Horizontal Direction
: 3-4mm
Horizontal Direction
: 5-6mm
44