Epson R200 - Stylus Photo Color Inkjet Printer Service Manual page 85

EPSON Stylus Photo R200/R210
9. After finishing PG Adjustment on the right, move "Carriage Unit" to the left edge
again, then check PG according to the flowchart in the Figure 3-11.
Start
Note:
Move "Carriage Unit" to
the right by using
"Timing Belt".
Yes
Does the Thickness
Gauge move?
No
Go to Step 10
Take up: PG gets wider
Take down: PG gets narrower
Figure 3-11. PG Checking (1)
10. Move "Carriage Unit" back to the left edge of the printer, then set the Thickness
Gauge (1.31mm) on the ribs (X3) of "Paper Guide, Front" in the same way as the
Figure 3-7.
ADJUSTMENT
Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take up "Bushing, Parallel
Adjust, Left" toward the
printer back by 1 notch.
Move "Carriage Unit" to
the right by using
"Timing Belt".
Yes
Does the Thickness
Gauge move?
No
Go Back to Step 7
Adjustment Except Adjustment Program
11. Check PGs on both the left and right according to the flowchart in the Figure 3-12.
Start
Check left PG.
Move "Carriage Unit" to
the right by using
"Timing Belt".
No
Does the Thickness
Gauge move?
Yes
Check right PG.
Move "Carriage Unit" to
the left by using "Timing
Belt".
No
Does the Thickness
Gauge move?
Yes
Go to Step 12
Figure 3-12. PG Checking (2)
12. After finishing the adjustment, screw "Bushing, Parallel Adjust, Left (Right)".
13. After screwing, check PGs on both the left and right again according to the
flowchart in the Figure 3-12.
Revision A
Go Back to Step 3
85